2022-11-17
Avoid high temperatures
The engine piston temperature is too high, which is easy to lead to overheating and melting, leading to cylinder blockage; Rubber seals, V-belts, tires, etc. Overheating, premature aging, performance degradation and service life reduction; The coils of starter, generator, regulator and other electrical equipment are overheated, easy to burn and scrapped.
Avoid rebellion
Do not install the engine cylinder seal upside down, otherwise premature ablation and damage may occur. The motor fan blades shall not be installed upside down; For tyres with herringbone pattern, the ground indentation after installation must ensure that the end of the herringbone pattern faces back.
Avoid dust
If the fuel filter, oil filter, air filter, hydraulic oil filter and various filters are too dirty, the filtering effect may be worse. Dirt on radiator fins of water tank, air-cooled engine block and cylinder head, radiator fins and other components will cause poor heat dissipation and high temperature. Avoid mistakes
Electric valve wrenches shall be installed in pairs. If it is not installed or lost, the valve will lose control and the piston will be damaged; If locking devices such as cotter pin, locking screw, safety plate or spring plate are not installed on the motor connecting rod, flywheel and drive shaft screws, serious use failure may occur; If there is no valve in the gearbox housing of the engine to lubricate the gears, severe oil leakage may occur.
Avoid cleaning
Do not use oil to clean the filter paper of engine air filter; Never use oil to clean leather parts.
Oil repellent
If the dry air filter element of the engine is polluted by oil, the highly concentrated mixture is easily sucked into the cylinder, resulting in insufficient air, increased fuel consumption and reduced engine power; If the V-belt is polluted by oil, it will accelerate its corrosion and aging; The oil on the brake shoes, dry clutch plates and brake belts will endanger driving safety. Tire rubber is very sensitive to oil corrosion, and it will soften or peel off when contacting with oil.
Avoid stress
The tire casing is stored for too long and cannot be turned over in time, resulting in extrusion deformation; The filter elements of air filter and fuel filter cannot be filtered reliably during extrusion; Do not press rubber seals, V-belts, oil pipes, etc.
Avoid duplication
Parts can only be used once, but some drivers or workshops use them to save money or do not understand the "taboos" that may lead to accidents.
Avoid fire
Rubber products, such as tires, V-belts, cylinder liner waterstops, rubber oil seals, etc., It may be easily damaged or damaged near the fire source. On the other hand, they may also lead to fire accidents.
|
Mobile
浙公网安备33028102001325号
